From f5b65444dd6eaab2632f1201de2ef10146d8ec56 Mon Sep 17 00:00:00 2001 From: paulusjacobus Date: Tue, 8 Mar 2016 19:43:54 +1100 Subject: [PATCH] Updated G Code in Marlin (markdown) --- G-Code-in-Marlin.md | 22 +++++++++++----------- 1 file changed, 11 insertions(+), 11 deletions(-) diff --git a/G-Code-in-Marlin.md b/G-Code-in-Marlin.md index da375f8..576ebd9 100644 --- a/G-Code-in-Marlin.md +++ b/G-Code-in-Marlin.md @@ -110,17 +110,17 @@ of M200 setting extrude-only move will be classified as retract depending on the direction ###Z Probe - [[G28]] - Home one or more axes. Note G28 clears the bed leveling compensation matrix so use G28 followed by G29 - [[G29]] - Probe the bed Z height at multiple points and enable bed leveling compensation (ABL). - [[G30]] - Probe the bed Z height at the current XY position. - [[G31]] - Dock Z Probe sled. - [[G32]] - Undock Z Probe sled. - [[M48]] - Measure Z Probe repeatability. To test the accuracy of your z probe for bed leveling (ret standard deviation). - [[M401]] - Lower auto bed leveling Z-probe with a servo, ensure you are safe above the bed to clear the Allen key. - [[M402]] - Raise Z-probe. Note: drives the servo - [[M420]] - Enable or disable Mesh Bed Leveling. - [[M421]] - Set a single Mesh Bed Leveling Z coordinate: X Y Z - [[M851]] - Set/fine tune the z probe offset. M851 Z-6.90, store with M500 in EEPROM (if enabled). + [[G28]] - Home one or more axes. Note G28 clears the bed leveling compensation matrix so use G28 followed by G29 + [[G29]] - Probe the bed Z height at multiple points and enable bed leveling compensation (ABL) + [[G30]] - Probe the bed Z height at the current XY position + [[G31]] - Dock Z Probe sled + [[G32]] - Undock Z Probe sled + [[M48]] - Measure Z Probe repeatability. To test the accuracy of your z probe for bed leveling (ret standard deviation) + [[M401]] - Lower auto bed leveling Z-probe with a servo, ensure you are safe above the bed to clear the Allen key + [[M402]] - Raise Z-probe. Note: drives the servo + [[M420]] - Enable or disable Mesh Bed Leveling + [[M421]] - Set a single Mesh Bed Leveling Z coordinate: X Y Z + [[M851]] - Set/fine tune the z probe offset. M851 Z-6.90, store with M500 in EEPROM (if enabled) ###Filament Diameter [[M404]] - Set (or display) Nominal Filament Diameter in mm: [N] (e.g., 3mm or 1.75mm)