From f06fef1da7eb91b568b9cb8bde575b343e606bc0 Mon Sep 17 00:00:00 2001 From: paulusjacobus Date: Tue, 8 Mar 2016 19:44:50 +1100 Subject: [PATCH] Updated G Code in Marlin (markdown) --- G-Code-in-Marlin.md | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-) diff --git a/G-Code-in-Marlin.md b/G-Code-in-Marlin.md index 576ebd9..999793d 100644 --- a/G-Code-in-Marlin.md +++ b/G-Code-in-Marlin.md @@ -110,17 +110,17 @@ of M200 setting extrude-only move will be classified as retract depending on the direction ###Z Probe - [[G28]] - Home one or more axes. Note G28 clears the bed leveling compensation matrix so use G28 followed by G29 + [[G28]] - Home one or more axes. Note G28 clears the bed leveling compensation matrix so use G28 followed by G29 [[G29]] - Probe the bed Z height at multiple points and enable bed leveling compensation (ABL) [[G30]] - Probe the bed Z height at the current XY position - [[G31]] - Dock Z Probe sled - [[G32]] - Undock Z Probe sled - [[M48]] - Measure Z Probe repeatability. To test the accuracy of your z probe for bed leveling (ret standard deviation) - [[M401]] - Lower auto bed leveling Z-probe with a servo, ensure you are safe above the bed to clear the Allen key - [[M402]] - Raise Z-probe. Note: drives the servo - [[M420]] - Enable or disable Mesh Bed Leveling - [[M421]] - Set a single Mesh Bed Leveling Z coordinate: X Y Z - [[M851]] - Set/fine tune the z probe offset. M851 Z-6.90, store with M500 in EEPROM (if enabled) + [[G31]] - Dock Z Probe sled + [[G32]] - Undock Z Probe sled + [[M48]] - Measure Z Probe repeatability. To test the accuracy of your z probe for bed leveling (ret standard deviation) + [[M401]] - Lower auto bed leveling Z-probe with a servo, ensure you are safe above the bed to clear the Allen key + [[M402]] - Raise Z-probe. Note: drives the servo + [[M420]] - Enable or disable Mesh Bed Leveling + [[M421]] - Set a single Mesh Bed Leveling Z coordinate: X Y Z + [[M851]] - Set/fine tune the z probe offset. M851 Z-6.90, store with M500 in EEPROM (if enabled) ###Filament Diameter [[M404]] - Set (or display) Nominal Filament Diameter in mm: [N] (e.g., 3mm or 1.75mm)