diff --git a/Change-Log.mediawiki b/Change-Log.mediawiki
new file mode 100644
index 0000000..19cc1e6
--- /dev/null
+++ b/Change-Log.mediawiki
@@ -0,0 +1,49 @@
+== Version 1.1 (in Development) ==
+* Reduced code size, depending on your configuration.
+* Danish language.
+* LCD Probe Z Offset now shows the actual (usually negative) offset value.
+* Improved support for Delta, SCARA, and COREXY kinematics.
+* Move parts of Configuration files to <code>Conditionals.h</code> and <code>SanityCheck.h</code>.
+* Clean up of temperature code.
+* Fix handling of invisible files. Files and folders starting with underscore are now visible.
+* Enhanced [[G29]] with improved grid bed leveling based on Roxy code. See documentation.
+* EEPROM layout updated to <code>V21</code>.
+* Short EEPROM output as G-Code – Replay to restore settings.
+* Added [[M204]] travel acceleration options.
+* Added <code>S0</code> option to [[M503]] for pure G-code output.
+* [[M204]] "<code>P</code>" parameter replaces "<code>S</code>." ("<code>S</code>" retained for backward compatibility.)
+* Support for more RAMPS-based boards.
+* Support for Mega Controller and Minipanel.
+* Configurator utility (in the early stages of development).
+* [[M404]] "<code>N</code>" parameter replaced with "<code>W</code>." ("<code>N</code>" is for line numbers only).
+* Much cleanup of the code.
+* Improved support for Cyrillic and accented languages.
+* Fix [[M303]] so it doesn't swallow commands while running.
+* LCD controller knob acceleration.
+* Improved compatibility with various sensors, MAX6675 thermocouple.
+* Improved support for [[M110]], with or without the extra <code>N</code> parameter.
+* Filament runout sensor support.
+* Filament width measurement support.
+* Support for TMC and L6470 stepper drivers.
+* Improved support for Texas Instruments DRV8811 stepper drivers.
+* Support for the [http://www.adafruit.com/products/931 SSD1306 Monochrome 128X32 I2C OLED Graphic Display].
+* Better support of G-Code <code>;</code> comments, <code>\</code>, <code>N</code> line numbers, and <code>*</code> checksums.
+* Moved GCode handling code into individual functions per-code.
+* Only one "cold extrusion prevented" message per command.
+* Fixed lcd display of Volumetric Multiplier, to show percent rather than scaling value.
+* Preliminary support for [[M111]] with debug flags TBD.
+* Support for Repetier <code>DEBUG_DRYRUN</code> flag via [[M111]].
+* Added [[FAN_MIN_PWM]] configuration option with fan-speed scaling.
+* Various bugs existing in 1.0.2 have been addressed.
+
+== Version 1.0.2 – Jan 7, 2015 ==
+* Fixed: #1038 Steppers were disabled during filament change
+* Display Z position on LCD without leading and trailing zeros
+* Fixed: #1315 DOGLCD and LCD_PROGRESS_BAR conflict
+
+== Version 1.0.1 – Dec 28, 2014 ==
+* Progress bar for character-based LCD displays.
+* SD Card folder diving up to 10 levels deep.
+
+== Version 1.0.0 ==
+* 1.0.0 was not tagged officially. This number applies to any Marlin before the 1.0.1 release.