From b489a4a346aee4d56b37e9265962ba780c82c416 Mon Sep 17 00:00:00 2001 From: paulusjacobus Date: Tue, 8 Mar 2016 19:48:37 +1100 Subject: [PATCH] Updated G Code in Marlin (markdown) --- G-Code-in-Marlin.md | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/G-Code-in-Marlin.md b/G-Code-in-Marlin.md index 999793d..2ccd997 100644 --- a/G-Code-in-Marlin.md +++ b/G-Code-in-Marlin.md @@ -115,12 +115,12 @@ extrude-only move will be classified as retract depending on the direction [[G30]] - Probe the bed Z height at the current XY position [[G31]] - Dock Z Probe sled [[G32]] - Undock Z Probe sled - [[M48]] - Measure Z Probe repeatability. To test the accuracy of your z probe for bed leveling (ret standard deviation) - [[M401]] - Lower auto bed leveling Z-probe with a servo, ensure you are safe above the bed to clear the Allen key + [[M48]] - Measure Z Probe repeatability. To test the accuracy of your z probe for bed leveling (returns standard deviation) + [[M401]] - Lower auto bed leveling Z-probe with a servo, ensure you are safe above the bed to clear the probe [[M402]] - Raise Z-probe. Note: drives the servo [[M420]] - Enable or disable Mesh Bed Leveling [[M421]] - Set a single Mesh Bed Leveling Z coordinate: X Y Z - [[M851]] - Set/fine tune the z probe offset. M851 Z-6.90, store with M500 in EEPROM (if enabled) + [[M851]] - Custom M code in Marlin to set/fine tune the z probe offset. (i.e. probe offset = 6.90 mm: M851 Z-6.90, and store with M500 in EEPROM (if enabled)) ###Filament Diameter [[M404]] - Set (or display) Nominal Filament Diameter in mm: [N] (e.g., 3mm or 1.75mm)